Hi-Temp Long Caps

Ideal for masking long bolts, tubes, or hard to reach areas, vinyl long caps are available in lengths up to 24" long.

Style: Available with Round End or Flat End tops.

ID: Long Caps should typically be sized to match the O.D. (outside diameter) of your part. Examples: If your O.D. is .625" (15.88 mm), use a .625" (15.88 mm) Long Cap.

Length: All Long Caps are available in any length up to the maximum shown, within .062" (1.57 mm) increments. On Round End caps, the inside length tolerance of ± .062" (1.57 mm) is measured to the center of the closed end. On Flat End caps, the inside length tolerance of ± .062" (1.57 mm) is measured along the side wall to the radius of the closed end, not down the center.

Wall thickness: Wall Thickness "C" is measured .250" (6.35 mm) from the open end, increasing slightly toward the closed end. Wall tolerance is ±.010" (0.25 mm).

Materials:
Hi-Temp Vinyl S-Caps